Automation
BHP-Lundin deploy Epiroc SmartROC D65 drills at Vicuña copper
Two automated surface rigs bring GPS navigation and data-rich drilling to Argentina's high-altitude open pit development.
Key takeaways
- BHP and Lundin Mining will deploy two Epiroc SmartROC D65 automated drill rigs at their 50:50 Vicuña copper joint venture in Argentina.
- The SmartROC D65 platform handles 110–229 mm production blastholes with GPS navigation and automated drilling cycles suited to high-altitude conditions.
- Onboard logging of penetration rate, torque, and air pressure supports real-time blastability and rock-mass characterization.
- The equipment choice gives both JV partners a common digital drilling platform for data integration across their copper portfolios.
- Remote monitoring and mine planning software integration enable direct pattern upload and real-time deviation tracking.
Two Epiroc SmartROC D65 surface drill rigs will be deployed at the Vicuña copper project in Argentina, a 50:50 joint venture between BHP and Lundin Mining. Epiroc Southern Cone General Manager Patricio Lagarini described Vicuña as one of the world's major emerging copper developments, according to details first reported by International Mining.
The SmartROC D65 platform is designed for 110–229 mm production blastholes and pre-split drilling in large open pits. The rigs bring automated drilling sequences and GPS-based hole navigation suited to the high-altitude Andean conditions where Vicuña is located.
Why it matters
The equipment choice positions the BHP-Lundin joint venture to integrate with a mature automation ecosystem rather than conduct isolated technology trials. Epiroc's SmartROC D65 fleet already includes autonomous D65 MKII units operating at Fortescue's Solomon and Eliwana operations. By selecting a common digital drilling platform, both JV partners can simplify data integration and performance benchmarking across their wider copper portfolios in Chile and Argentina.
Technical capabilities for mine planners
The SmartROC D65 rigs are configured for both down-the-hole and top-hammer drilling modes. Automated drilling cycles reduce operator input during extended production runs in thin-air conditions typical of Andean elevations.
GPS hole navigation enables tighter collar position tolerances compared to manual survey-marked patterns. Onboard logging captures penetration rate, torque, and air pressure data that supports blastability analysis and rock-mass characterization.
Remote monitoring allows drill performance and utilization to be tracked from off-rig control centers. The platform integrates with mine planning software, permitting direct upload of drill patterns and real-time deviation checks. Fuel-efficient compressor and hydraulic systems are designed to limit derating at high elevations.
Implications for drill-and-blast engineering
For mine planners and drill-and-blast engineers, the deployment signals early adoption of fully programmable, data-rich drilling infrastructure for future large-scale pit development. The combination of automated sequences, precise positioning, and continuous data capture creates opportunities to refine blast designs based on measured drilling performance rather than assumed rock properties.
The details were first reported by International Mining.